Once keepers are in place, start turning the bolt counterclockwise to relieve the pressure of the valve spring.Place a small amount of the provided grease on the flat tip of the screw driver and place a keeper over it, the grease will hold the keeper in place and allow you to place the keepers easily.To reinstall the valve assembly, place the valve (if removed for some reason), valve seals, valve spring, and retainer compress the assembly using the same steps as above.Using the magnetized end of the screw driver remove the keepers.Place the retainer cap on top of the retainer, lubricate the long bolt with provided grease and start turning the long bolt clockwise with the help of a wrench (14mm) to apply pressure to the retainer cap and compress the valve spring until the keepers are completely visible and can come out. Easily Compress Valve Springs On Overhead Valve Engines The ARES Valve Spring Compressor lets you quickly and easily compress valve springs, even in hard to.Align the holes on the tool with the one the head, and place the shorter bolts and washers to secure the tool. JEGS 555-W89409 Valve Spring Compressor Make those between-round valve spring changes easier with JEGS Performance Tool valve spring compressors. If using with the head out of the engine compartment, put something below the valve to keep it pressed upward. If using with the head on the block, cylinders need to be pressurized to 100PSI to prevent the valve from falling into the cylinder. Included is a small magnetized screw driver to very easily remove or install the keeper.No need to remove the rocker arm shafts.Will not slip and scratch or damage your head like universal clamp type valve spring compressors.The EuroExport 4G63 valve spring compressor tool makes installing valve springs in your DSM or Evo easy! Simply align the holes on the aluminum body of the valve spring compressor with the ones on the head, bolt it using the provided short bolts, place the valve spring, retainer and retainer cap on the retainers, bolt down the long bolt, place the keepers using the magnetized screwdriver and it's done! AICEL LS Valve Spring Compressor Tool, Automotive Valve Seal Adjustment Installation Tools, Aluminum Alloy Valve Spring Removal Kit, Car Tuning Accessories Compatible with LS1 LS2 LS3 LS6 Engines.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |